Lead Acid Battery Charger LM317

Lead Acid Battery Charger circuit is highly recommended to recharge battery. And recommended that maximum voltage 24V 7A battery, so you can recharge a battery simultaneously. Battery Charger has been little use of several components such as diodes, electrolytic capacitors, transistors, resistors, and also for strengthening of the voltage and current stresses. And also do not forget to lowering electric voltage 220V to 20V-35V 5-10 Ampere suitable for Lead Acid Battery Charger circuit.

for Figure Schematic circuit Lead Acid Battery Charger, you can see below :

List of components for the circuit Lead Acid battery:

R1               = 1Ω 2w

R2               = 100Ω

R3               = 220Ω

R4               = 10KΩ Trim

D1 - D5       = IN4004

Q1               = BC547

IC 1             = LM317

C1 - C2       = 1000µF 50V

C3               = 470µF 50V

Transformer I mentioned above can use the 5A - 10A with a secondary voltage of about 20Volt-35Volt AC. My advice to IC please be cooler, because when the circuit and well even IC LM317 works it causes IC hot. Also to assemble the components using PCB (Printed works Circuit Board) qualified with a good track, as well as the components that will be used not forget to check back whether good or not, so it will also produce good results.