This circuit above is a cheap version stun gun circuit that is powered by two AA baterry. The output of this electronic project is about 350V dc. The heart of the circuit is the oscillator that is composed of Windings and transistor.
3V electronic stun gun circuit
Part List:
- Transistor - Tip41 or similar
- Resistor - 100-ohms 1W
- Capacitor-100nF
- C-1.2uF 1000V or any cap with 1000V rating
- D-1N4007 diode or similar
Primary and Feedback winding
TIP41 pins
Primary winding P is composed of 16 turns of #24 AWG wire, feedback F is composed of 8 turns of #24 AWG wire, and secondary winding S is composed of 270 turns of #30 AWG magnetic wire. P1 is connected to the collector of transistor, F2 to the 100-ohms resistor at transistor base. F1 and P2 to the battery. The output of Sec winding is rectified by Diode Bridge. The output capacitor is an electrolytic type that is rated 400V above. Capacitance of the output capacitor depends on what available on hand, but always keep in mind that the higher the value the better. this simple electronic project is dangerous when accidentally touched, thus avoid holding the output and discharge the capacitor before and after using.
One of the uses of this circuit is the camera flasher circuit.
Tidak ada komentar:
Posting Komentar